Zandronum

I tried following this tutorial: https://sites.google.com/site/sicamores ... -3d-models,
word by word to place a 3d model I wanted inside this engine. It failed and I just can't figure out why.

Here is the file:

https://www.dropbox.com/s/yex3c3fccuq51 ... s.pk3?dl=0

I would also like to add that I'm astonished why misfit 3d distorts the tail end of my model when it is saved as a md3 file. When I save the file, the model seems to appear fine, but once I try to load it in again, it shows the distortion on the tail. Here is the original obj file:

https://www.dropbox.com/s/r1zejhhmvs5irxo/Rex.zip?dl=0

its the scale, i did it the same and it worked but it was too small to see
change the 3 numbers in "scale"

Thanks man.

Actually, no. That didn't work when I finally got back to testing it. :(