I tried following this tutorial: https://sites.google.com/site/sicamores ... -3d-models,
word by word to place a 3d model I wanted inside this engine. It failed and I just can't figure out why.
Here is the file:
https://www.dropbox.com/s/yex3c3fccuq51 ... s.pk3?dl=0
I would also like to add that I'm astonished why misfit 3d distorts the tail end of my model when it is saved as a md3 file. When I save the file, the model seems to appear fine, but once I try to load it in again, it shows the distortion on the tail. Here is the original obj file:
https://www.dropbox.com/s/r1zejhhmvs5irxo/Rex.zip?dl=0
Problem loading 3d model
-
- Registered just to make one post
- Posts: 1
- Joined: Sun Jul 23, 2017 4:10 am
Re: Problem loading 3d model
its the scale, i did it the same and it worked but it was too small to see
change the 3 numbers in "scale"
change the 3 numbers in "scale"
-
- Posts: 46
- Joined: Sun Oct 26, 2014 5:28 pm
Re: Problem loading 3d model
Actually, no. That didn't work when I finally got back to testing it. :(