Problem loading 3d model

Discuss all aspects related to modding Zandronum here.
Post Reply
Hornetzero
 
Posts: 46
Joined: Sun Oct 26, 2014 5:28 pm

Problem loading 3d model

#1

Post by Hornetzero » Sat Feb 11, 2017 12:11 am

I tried following this tutorial: https://sites.google.com/site/sicamores ... -3d-models,
word by word to place a 3d model I wanted inside this engine. It failed and I just can't figure out why.

Here is the file:

https://www.dropbox.com/s/yex3c3fccuq51 ... s.pk3?dl=0

I would also like to add that I'm astonished why misfit 3d distorts the tail end of my model when it is saved as a md3 file. When I save the file, the model seems to appear fine, but once I try to load it in again, it shows the distortion on the tail. Here is the original obj file:

https://www.dropbox.com/s/r1zejhhmvs5irxo/Rex.zip?dl=0

Carcass696
Registered just to make one post
Posts: 1
Joined: Sun Jul 23, 2017 4:10 am

Re: Problem loading 3d model

#2

Post by Carcass696 » Thu Nov 09, 2017 8:58 pm

its the scale, i did it the same and it worked but it was too small to see
change the 3 numbers in "scale"

Hornetzero
 
Posts: 46
Joined: Sun Oct 26, 2014 5:28 pm

Re: Problem loading 3d model

#3

Post by Hornetzero » Sat Jan 20, 2018 3:15 am

Thanks man.

Hornetzero
 
Posts: 46
Joined: Sun Oct 26, 2014 5:28 pm

Re: Problem loading 3d model

#4

Post by Hornetzero » Sat Jan 20, 2018 4:59 pm

Actually, no. That didn't work when I finally got back to testing it. :(

Post Reply