Page 1 of 1
3D floors with slopes
Posted: Fri Jul 06, 2012 9:30 pm
by Torvald
What do? I honestly don't even know where to begin. 3D floors aren't hard, but I have no idea how to do slopes with 3d floors. An example would be greatly appreciated if possible.
RE: 3D floors with slopes
Posted: Fri Jul 06, 2012 9:38 pm
by Watermelon
You gotta make the exact same dimensions as the floor you want to slope, then apply a slope to the sector outside of the map. It's difficult as hell, you have to visually see the area inside the sloped room and know that the space in the 3D sector room is the obscured space in the real map.
RE: 3D floors with slopes
Posted: Sat Jul 07, 2012 1:52 pm
by ZzZombo
Use GZDoom Visual mode in DB2 for that.
RE: 3D floors with slopes
Posted: Sat Jul 07, 2012 7:15 pm
by Devon
http://zdoom.org/wiki/Sector_Set3dFloor
A few tips under "Important Notes" about slopes and 3D floors there. Other than that I can't help you, good luck!
RE: 3D floors with slopes
Posted: Sun Jul 08, 2012 12:34 am
by Torvald
Thanks Devon :D